We&rsquove finished building three&nbspheavy-duty work benches and one of two&nbspfolding wood sawhorses. Another important part of a workshop is good lumber storage. Up until now we&rsquove been piling boards on the floor, and it&rsquos been a pain to keep moving them to make room for projects. Our solution is a simple wall-mounted wooden lumber rack. This article shares the instructions for building this rack.
I had one-half of a sheet of plywood left over from building the workbenches. If I didn&rsquot have that handy, this lumber rack would cost about $55, since I would have had to purchase two whole sheets. By eliminating two of the vertical supports and being careful to minimize waste, you can build this rack with only one sheet of plywood, almost cutting the total cost in half. So let us take a look at favorite wall mounted kitchen storage oak with 11 pictures below.
1. Simple Unstained Oak Wood Floating Shelves On White Painted Wall
Many of the cuts can be made using a circular saw. If you take that route, I suggest using guides to ensure perfectly straight cuts, because circular saws are otherwise difficult to control. We use our table saw and mitre saw, because they make the cuts much easier, since we can use built-in guides.
2. White Kitchen Pantry Storage Cabi Made Of Wood With Profile
3. Tropical Houses Oak Wood Kitchen Storage Cabis Grey Marble
The entire structure is built out of plywood, and that means this project involves making a lot of rip cuts. A cabinet saw would have been really useful. I don&rsquot have one so I made the best out of what I do have.
Here are the pieces you&rsquoll need to cut with your table saw. I shortened my vertical supports (fourth item below) because I had to work around a garage door. Leave them at 79&Prime if you have the space. Also, do not rip the entire length of the plywood to make your vertical supports, because you&rsquoll be using the excess at the end of the sheet for further shelf supports. (In other words, before cutting the vertical supports, you should cross-cut the plywood at 79&Prime)
4. Unpolished Oak Wood Wall Mounted Kitchen Shelves Attached On Grey
The upper cleat needs to have an angled backside, from which you will hang the vertical supports. You want the width on the longest side to measure 5&Prime, and cut it at a 45&deg angle. This will make the shorter side approximately 4-1/4&Prime.